Short Course on Resources – What You Should Know

Beginner’s Guide to Crown Molding and Pot Light Installation It is a challenge to do crown molding and pot lighting installation but with the right knowledge and skills, you will be able to do it with ease. How to attain a nice looking crown molding? A large and elegant crown that is easier to install and less expensive than single-piece crown molding can be achieved with combined standard crown molding having two-pieces of base trim. It is a good idea measuring the length of the wall for the crown molding so you can buy pieces that are long enough to span each wall, and to prevent scarfing pieces together. Choose the same tone if you want to use a light-colored stain, and crown molding can be installed using a hammer, handsaw, and miter box. We highly advised using brad nailer and miter saw for faster work. You can easily combine crown molding with other trim for a richer look. Unlike one-piece crown wherein you need to drive nails where there is framing behind the drywall, you can use a built-up crown for better nailing. Most carpenters put lines and marks right on the ceilings and walls and hide them with paint. For an easier work, you can use an easy-release masking tape with at least 2 inches wide to stick on walls and ceilings. You need to wait for a couple of weeks if you plan to paint the ceiling or walls before applying the tape. Now, you can install the trim over the masking tape, and leave it in place to protect your ceiling and walls when you paint or apply a finishing coat. For the crown molding trim placement, with the first piece in place, you just have to place the other pieces right next to it and working around the room following the same direction for the maximum utilization of the 45-degree cuts using a miter saw. By doing so, your molding job becomes easier, and you can also use construction adhesive on the rail (even those areas where you can nail into ceiling joists and studs) for you to use just enough nails, holding the trim into its place until the adhesive sets, with fewer nail holes to fill. You have to miter the ceiling rails both outside and inside corners. When coping wall rails, it is like coping the crown but you need to stand the trim against the saw’s fence when you’re making the 45-degree miter, and install the outside corners the last to avoid coping both ends. It can be daunting and confusing having a DIY crown molding and pot installation project, so do not hesitate to contact a professional carpenter to help you. Visit our website and check the best crown molding and pot installation companies today!The 10 Rules of Resources And How Learn More

Practical and Helpful Tips: Lights